Daily Maintenance Of Molding Machine
Jan 05, 2022
1. Before taking over the shift every day, check each lubricating point in the equipment to see whether the lubricating oil (grease) is sufficient, and replenish the lubricating oil (grease) if necessary.
2. Listen to whether the operating equipment has abnormal sound. If the operating sound is abnormal, find relevant personnel if necessary to decide whether to shut down for maintenance and eliminate the fault according to the situation.
3. Check whether the process temperature control and instrument display are normal. In case of any abnormality, check whether they are normal? Check whether the heating device and temperature control system work normally, and ask relevant personnel for maintenance if necessary.
4. After taking over the shift, first check whether the position of each work switch and button is correct, whether the limit switch is loose, and whether the safety door works flexibly and accurately to ensure production safety.
5. Before the first train starts to feed into the hopper, check the hopper first? Whether the hopper is clean and remove all sundries in and on the hopper.
6. Note that the idle running time of the screw shall not exceed 3min. Except for the trial run before production, the screw shall not be allowed to idle run at ordinary times.
